So, this is a fun little toy called a "Ring Gag". The last several tutorials have been pretty advanced and required some pretty specialized tools that not everyone has. I would like to get back to the basics and do a few simple tutorials that require no specialized equipment and easy to obtain parts. While I do use a sewing machine to sew the nylon webbing, it is certainly possible to make this project with just a needle and thread.
You'll want to keep in mind that the 1" webbing that's used as a strap in this gag isn't as comfortable as a narrower strap would be, but I believe that the wider strap is necessary to help keep the sub from twisting the ring sideways in their mouth.
If you want, feel free to use a narrower webbing.
- 2 - 18" x 1" Nylon Webbing
- 1 - 1" Strap Adjuster
- 1 - 1.5" Inside Diameter Steel Ring
- Sewing Machine or Needle and Thread
- Scissors
First, round up all of your parts. I specified two 18" lengths of the nylon webbing. That should be adequate for all but the smallest or largest heads. If you have a very large head, you might want to add a couple of inches to the straps :-)
Next, sew one of the straps to the steel ring. The folds in the picture are approximately 1 inch. I like to add the third layer to ensure that the webbing doesn't fray.
I like to sew over the end of the other strap (the one that snakes through the strap adjuster) so that it doesn't fray. Remember to orient the fold in the opposite direction as the fold on the other end of the strap so that the fold is down when it's been run through the strap adjuster.